How long do Fit Once™ seals last? The data.
At Buycombi we don’t just claim the Fit Once™ cartridge is designed to last the lifetime of your boiler — we’ve tested it. This page summarises the engineering and destructive testing data behind that claim.
Seal Longevity Testing
To establish realistic service intervals we conducted destructive testing on the Fit Once™ seal canister under two conditions — clean system water with a magnetic filter, and heavily contaminated water without a filter.
The test assumed 75 diverter valve activations per day — a realistic figure for a normal household accounting for hand washing, showers, washing up and central heating demand.
The clean water test seal was first installed in a working household boiler from December 2019 to July 2020 — approximately 7 months of real-world use. It was then transferred to a controlled test environment where cycling continued until the equivalent of 6.4 years of normal household use had been accumulated. No seal failure was recorded at this point.
The contaminated water test was conducted entirely in a controlled test environment simulating heavily contaminated system water without a magnetic filter. Seal stiffening was observed after the equivalent of approximately 1.2 years of normal household use.
| Test condition | Equivalent years tested | Outcome |
|---|---|---|
| Clean water with magnetic filter | 6.4 years | No seal failure |
| Contaminated water, no filter | 1.2 years | Seals began to stiffen |
What this means in practice:
With clean system water and a magnetic filter fitted, Fit Once™ seals demonstrated no failure after the equivalent of over 6 years of normal household use. This supports our recommendation to replace the seal canister every 3 years under these conditions — giving a comfortable safety margin.
Without a magnetic filter and with contaminated system water, seal performance deteriorated after the equivalent of approximately 1.2 years. This supports our recommendation to check and replace seals at the annual boiler service when system water quality is unknown or a filter is not fitted.
The test data confirms that system water quality is the single biggest factor in seal longevity — which is why we always recommend fitting a magnetic filter and using a quality inhibitor.
Material Selection
The Fit Once™ cartridge body is manufactured from Noryl™ FE1630PW — a glass-filled PPE resin selected after a rigorous comparison study with Zytel™ (PA6.6 nylon), which is commonly used in water management products.
The selection process involved:
- Data sheet comparison of both materials under relevant stress conditions
- Independent stress and strain modelling by Sabic, a global plastics manufacturer
- Long-term water immersion performance data
Why Noryl™ was selected over Zytel™:
| Property | Zytel™ PA6.6 | Noryl™ FE1630PW |
|---|---|---|
| Water absorption | ~5% | Less than 0.3% |
| Tensile strength retained after 10 years | ~25% | ~50% |
| Dimensional stability in water | Moderate — swells with moisture | High — minimal dimensional change |
| Young’s Modulus | 4,876 MPa (water adjusted) | 8,771 MPa |
Noryl™ retains approximately 50% of its tensile strength after more than 10 years in water, compared to approximately 25% for standard PA6.6. Its low moisture absorption means the cartridge maintains precise dimensional tolerances throughout its service life — critical for effective O ring sealing.
Stress modelling was conducted at loads more than 13 times the actual operating loads. Neither material showed unacceptable levels of stress, strain or displacement at these elevated loads — confirming the cartridge design has a substantial safety margin.
The O Ring Seals
The working O ring seals inside the canister are sourced from one of Europe’s largest seal manufacturers and specially formulated with added lubricant for extended life. The stainless steel pin against which they seal is specified to the correct surface finish — too smooth and the O rings cannot form an effective seal; too rough and they wear prematurely.
Zero Warranty Claims
Since the Fit Once™ cartridge launched in 2017, Buycombi has received zero warranty claims. With thousands of cartridges in use across the UK and EU, this is the strongest real-world validation of the engineering data above.
Service Recommendations
Based on the test data:
- With magnetic filter and clean system water — replace seal canister every 3 years
- Without magnetic filter or unknown water quality — replace seal canister at annual boiler service
- Always use a quality inhibitor — this significantly extends seal life and protects all boiler components
Replacement seal canisters are available from buycombi.com at £7.99.
Patent Information
The Fit Once™ cartridge design is protected by UK patent GB2569552 (granted 2017) and European patent EP3990836. It is the only serviceable diverter valve cartridge on the market.
